INSTRUCTIONS FOR AIR ADJUSTMENT - PART #ALC-3350

Visit our web store for this item

1. Take part out brass block and part #50-ALC.

2. Loosen part #33 and move it up ( loosening screw #21).

3. Take part Alc#3350 with big open side (see photos), and put it to the #33 side and the smaller hole to the part #50 side with screw-in part facing out for adjustment. (REFER TO PHOTOS)

4. Lower part #33 and tighten it. You should be ready to go. ( see photos)

5. Adjust as needed with a screwdriver (see photo below) for the proper air flow watch your mantle light.

If mantle light goes out like your out of fuel, but you know your not then you may need to add part Alc.#50 (see photo below of part and how to install part).

When preheating with Alcohol Fuels go here for Instructions

Lighting instructions for lanterns without preheater (part #226)

More Alcohol Lantern Instructions

Video demonstration of part 3350